KNIPEX - 33 03 160 Tools - Duckbill Pliers, Chrome (3303160)

Product Information

KNIPEX, Stahlwille and Wiha pliers and cutters all stand for quality made in Germany. Knipex is considered the worldwide leading pliers manufacturer for professional users in trade and industry.

Knipex 81006 85mm - 140mm J4 Straight Internal Circlip Pliers

Over time and with use, scissors can dull even if you’re fairly careful. More inexpensive types of scissors tend to dull faster and easier than more expensive, high-end scissors. To avoid damaging the slot or receptacle in the head of the screw, the use of cordless power drills fitted with a removable tip driver to remove or install screws is not recommended, as the drill does not have a slip-clutch installed. Our extensive range include all types, shapes and prices – from high quality to economical – for a variety of applications like cutting wire, bolts, plastics, pipes or sheet metal, twisting, bending, forming, depanelling, clamping or fastening, including diagonal cutters, round-nose pliers, crimping pliers, bolt cutters, stripping pliers, needle nose pliers, monier pliers, cable cutters, circlip pliers,installation pliers, diagonal cutters, combination pliers, needle nose pliers, cable cutters, water pump pliers and much more. For Electronics Manufacturing we offer Electronic needle nose pliers, Electronic diagonal cutter, ESD needle nose pliers, ESD diagonal cutter and VDE 1000V insulated pliers and cutters for electricians.

When using a screwdriver on a small part, always hold the part in the vise or rest it on a workbench. Do not hold the part in the hand, as the screwdriver may slip and cause serious personal injury. The pliers are designed for long-reach applications and pulling objects in very confined spaces. You can use them as hose clamp pliers to remove hose clamps on gas lines and radiator hoses. Uses The category of special wrenches includes the crowfoot, flare nut, spanner, torque, and Allen wrenches.

Duckbill Pliers | Products | KNIPEX

In general practice, a pin or bolt which is to be driven out is usually started and driven with a drive punch until the sides of the punch touch the side of the hole. A pin punch is then used to drive the pin or bolt the rest of the way out of the hole. Stubborn pins may be started by placing a thin piece of scrap copper, brass, or aluminum directly against the pin and then striking it with a hammer until the pin begins to move. The cordless hand-held power screwdriver has replaced most automatic or spiral screwdrivers for the removal of multiple screws from an airframe. Care must be exercised when using a power screwdriver; if the slip clutch is set for too high a setting when installing a screw, the screwdriver tip will slip and rotate on top of the screw head, damaging it. The screw should be started by hand, to avoid driving the screw into the nut or nutplate in a cross-threaded manner.Punches are used to locate centers for drawing circles, to start holes for drilling, to punch holes in sheet metal, to transfer location of holes in patterns, and to remove damaged rivets, pins or bolts. Solid or hollow punches are the two types generally used. Solid punches are classified according to the shape of their points. So sometimes I use these scissors to trim the batting when making quilts as I can cut very close to the seams without cutting the thread or the fabric. Always keep the faces of hammers and mallets smooth and free from dents, chips, or gouges to prevent marring the work.